Actually, worse than that; using the 10T transceiver with it. BUT, I got it to WORK! (found the key, namely LP at ) Part A (same as above): downloaded XP pro x64 mounted ISO Start->Run->'printui /s /t2'-> ctrl+shift+enter (to run as admin) Add. -> x64-> Have Disk -> amd64 ntprint.inf -> Apple ->Laserwriter 16/600 PS Then: Control Panel ->Devices and Printers, Add Printer, Add Local Printer, Create a New Port, Standard TCP/IP Port, Add the printer's IP address, (wait several minutes for it to time out), tell it Generic Network Card, (wait for it to time out again), Have Disk, choose the same NTPRINT.inf file as above, tell it to keep the current driver, finish. Naturally, it appears to have loaded, but can't talk to the printer, though I can telnet to it. Not to make it print to the network. Part B: printing to it Control Panel Programs and Features Turn Windows features on or off Expand Print and Document Services Check LPR Port Monitor OK Go to printer Right-click->printer properties->Ports Check the port you've set for the printer (the Standard TCP/IP Port), then click Configure Port set port to 515 (do this first; it grays out when you set protocol). ![]() View and Download Apple LaserWriter 16/600 PS setup, connection and use online. LaserWriter 16/600 PS Printer pdf manual download. Set protocol to LPR, Queue Name = lp (lowercase LP), LPR Byte Counting Enabled. Note that this is FINICKY. All these settings have to be just right. If any of them are off, it won't work. MANY THANKS, Alan! Any way I can repay you for the help? I'm not going to PASS this year, so I doubt I'll be anywhere near you anytime soon.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
September 2018
Categories |